Home » Tip of the Day » Drilling » Pocket-size gauge for setting pocket-hole bits

Tip of the Day

Daily woodworking tips to improve your accuracy, better organize your shop, make your tools work harder, and help you work safer. Stop back daily for more woodworking tips from the editors at WOOD magazine and our enthusiastic readers.


Pocket-size gauge for setting pocket-hole bits

Pocket-size gauge for setting pocket-hole bits

After reading your review of pocket-hole jigs in issue 152, I bought a jig and was satisfied except for one small problem. I found that changing the depth of the stop collar was awkward because I had to hold the drill bit, a ruler, and the stop collar with one hand while I tightened the collar with the other. To simplify the task, I built this stop collar gauge from scrap 3/4″ medium-density fiberboard (MDF).

Because the stepped drill bit is 3/8″ diameter, I drilled the gauge holes slightly oversize with a 13/32″ bit. The drawing at shows how deep to drill the holes to correctly set the bit for 1/2″, 3/4″, and 1 1/2″-thick materials. I then drilled a 3/16″ hole in the bottom of each gauge hole to make room for the pilot bit. To use the gauge, loosen the stop collar, drop the pocket hole bit into the gauge hole, and then re-tighten the collar.
—Dan Jansen, Sigel, Ill.

© Copyright , Meredith Corporation. All Rights Reserved | Privacy Policy | By using this site, you agree to our Terms of Service.